Int3 Interrupt - Renesas M16C Series Hardware Manual

R8C/11 Group
______

10.2.4 INT3 Interrupt

_____
INT3 interrupts are triggered by INT3 inputs. The TCC07 bit in the TCC0 register should be se to "0"
______ _______
(INT3). The INT3 input has a digital filter which can be sampled by one of three sampling clocks. The
sampling clock is selected using the TCC11 to TCC10 bits in the TCC1 register. The IR bit in the
INT3IC register is set to "1" (interrupt requested) when the sampled input level matches three times.
The P3_3 bit in the P3 register indicates the previous value before filtering regardless of values set in
the TCC11 to TCC10 bits.
_______
The INT3 pin is shared with the TC
When setting the TCC07 bit to "1" (f
bit in the INT3IC register is set to "1" (interrupt requested) every f
f clock cycle.
RING128
Figure 10.14 shows the TCC0 and TCC1 registers.
Rev.1.20 Jan 27, 2006
REJ09B0062-0120
______
pin.
IN
RING128
page 63 of 204
_____
), INT3 interrupts are triggered by f
RING128
______
10.2 INT Interrupt
clock. The IR
RING128
clock cycle or every half