A/D Converter - Renesas M16C Series Hardware Manual

R8C/11 Group

19.6 A/D Converter

(1) When writing to each bit but except bit 6 in the ADCON0 register, each bit in the ADCON1 register, or
the SMP bit in the ADCON2 register, A/D conversion must be stopped (before a trigger occurs).
When the VCUT bit in the ADCON1 register is changed from "0" (V
connected), wait at least 1 µs before starting A/D conversion.
(2) When changing AD operation mode, select an analog input pin again.
(3) In one-shot mode, A/D conversion must be completed before reading the AD register. The IR bit in
the ADIC register or the ADST bit in the ADCON0 register can indicates whether the A/D conversion
is completed or not.
(4) In repeat mode, the undivided main clock must be used for the CPU clock.
(5) If A/D conversion is forcibly terminated while in progress by setting the ADST bit in the ADCON0
register to "0" (A/D conversion halted), the conversion result of the A/D converter is indeterminate. If
the ADST bit is set to "0" in a program, ignore the value of AD register.
(6) A 0.1 µF capacitor should be connected between the AVcc/V
Rev.1.20 Jan 27, 2006
REJ09B0062-0120
page 193 of 204
not connected) to "1" (V
REF
pin and AVss pin.
REF
19. Usage Notes
REF