Power-On Reset Function - Renesas M16C Series Hardware Manual

R8C/11 Group

5.1.3 Power-on Reset Function

The power-on reset is the function which can reset the microcomputer without the external reset
____________
circuit. The RESET pin should be connected to the V
power-on reset function, the function turns to active and the microcomputer has its pins, CPU and
SFR initialized. When a capacitor is connected to the RESET pin, always keep the voltage to the
____________
RESET pin 0.8 V
When the input voltage at the V
chip oscillator clock starts. When the operation counts the low-speed on-chip oscillator clock for 32
times, the internal reset is released. Then the program is executed starting from the address indi-
cated by the reset vector. The initialized pins and registers and the status thereof are the same as in
hardware reset 1 excluding the following bits.
• The D40 bit in the D4INT register turns to "1" automatically (voltage detection interrupt enabled)
• The D46 bit in the D4INT register turns to "1" automatically (hardware reset 2 when going through
Vdet)
Additionally, the hardware reset 2 turns to active after the power-on reset. This is because the VC27
bit in the VCR2 register is set to "1" (voltage detection circuit enabled) after the power-on reset same
as the hardware reset 1, so that hardware reset 2 active conditions are all satisfied including above
D40 and D46 bit conditions.
Figure 5.5 shows the power-on reset circuit. Figure 5.6 shows the power-on reset operation.
RESET
f
RING-S
≥
V Vdet detection
CC
Figure 5.5 Power-on Reset Circuit
Rev.1.20 Jan 27, 2006
REJ09B0062-0120
or more.
CC
pin reaches to the Vdet level, count operation of the low-speed on-
CC
5-bit
counter
Trigger
page 18 of 204
pin via about 5 kΩ pull-up resistance using the
CC
____________
Q
S
R
5.1 Hardware Reset
Internal reset signal