Differences Between Mcu And Emulator; A/D Converter And D/A Converter - Renesas H8 Series User Manual

7.3

Differences between MCU and Emulator

When the emulator is turned on or initialized, or the system is reset, there are some differences in the initial
values in some of the general registers between the MCU and the emulator as shown in table 7.2.
Table 7.2 Initial Value Differences between MCU and Emulator
Status Register
Power-on/ PC
initialized ER0 to ER6
ER7 (SP)
CCR
Reset command PC
ER0 to ER6
ER7 (SP)
CCR
7.3.1

A/D Converter and D/A Converter

Due to the use of a user system interface cable, there is a slight degradation in the A/D and D/A conversion than
that quoted in the Hardware Manual for the MCU being emulated.
E6000 Emulator
Reset vector value
Undefined
H'10
The I mask is set to 1 and the
other bits are undefined
Reset vector value
Undefined
H'10
The I mask is set to 1 and the
other bits are undefined
MCU
Reset vector value
Undefined
Undefined
The I mask is set to 1 and the
other bits are undefined
Reset vector value
Undefined
Undefined
The I mask is set to 1 and the
other bits are undefined
177