Table of Contents
Advertisement
1
Figure 35. Removing the bezel and the cover from the internal drive
5. Inspect the drive to decide which of the following conditions most closely match the symptom on the
drive:
v Tape spooled off the supply reel - All the tape appears to be on the takeup reel and no tape is on
the supply reel (inside the cartridge). Test the drive after the procedure is completed.
v Tape pulled from leader pin (or broken at the front end) - All the tape appears to be on the
supply reel (inside the cartridge) and little or no tape appears to be on the takeup reel. The leader
block is positioned in the takeup reel. Return the drive after the procedure is completed.
v Tape broken in mid-tape - Tape appears to be on both the supply reel (inside the cartridge) and
takeup reel. Test the drive after the procedure is completed.
v Tape tangled along tape path - Tape appears to be tangled and damaged but intact. Return the
drive after the procedure is completed.
-- OR --
No damage to tape (or no apparent failure) - There appears to be no damage or slack to the tape.
Return the drive after the procedure is completed.
Tape spooled off supply reel
Attention: DO NOT TOUCH THE OUTER GUIDE RAIL ( 2 in Figure 36 on page 89). THIS RAIL IS
VERY DELICATE AND EASILY DAMAGED.
1. From the takeup reel, pull an arm 's length of tape around the rear of the tape path and over the
head and rollers on the left side of the drive.
2. Set the drive on its left side with the head and tape path facing up.
3. Make sure that the tape is not twisted. Untwist tape if required.
4. Moisten a cotton swab with water and wet approximately 13 mm (0.5 in.) of the tape end and feed it
onto the supply reel (inside the cartridge).
5. Turn the supply reel ( 4 in Figure 36 on page 89) clockwise, allowing the moistened tape to adhere
to the hub as it winds around the supply reel (inside the cartridge).
88
IBM TS2280: Setup, Operator, and Service Guide Machine Type 3580 Model H8S
1
1
Hide quick links:
Advertisement
Table of Contents
