A-20 Set Config Switch Parameters - Qlogic SANbox 5602 User Manual

0
AdminState
BroadcastEnabled
InbandEnabled
FDMIEnabled
FDMIEntries
DefaultDomainID
DomainIDLock
SymbolicName
R_A_TOV
E_D_TOV
PrincipalPriority
ConfigDescription
59097-01 A
Table A-20. Set Config Switch Parameters
Parameter
Switch administrative state: online, offline, or
diagnostics. The default is Online.
Broadcast. Enables (True) or disables (False)
forwarding of broadcast frames. The default is True.
Inband management. Enables (True) or disables
(False) the ability to manage the switch over an ISL.
The default is True.
Fabric Device Monitoring Interface. Enables (True) or
disables (False) the monitoring of target and initiator
device information. The default is True.
The number of device entries to maintain in the FDMI
database. Enter a number from 0–1000. The default
is 1000.
Default domain ID. The default is 1.
Prevents (True) or allows (False) dynamic
reassignment of the domain ID. The default is False.
Descriptive name for the switch. The name can be up
to 32 characters excluding #, semicolon (;), and
comma (,). The default is SANbox Manager.
Resource Allocation Timeout Value. The number of
milliseconds the switch waits to allow two ports to
allocate enough resources to establish a link. The
default is 10000.
Error Detect Timeout Value. The number of
milliseconds a port is to wait for errors to clear. The
default is 2000.
The priority used in the FC-SW-2 principal switch
selection algorithm. 1 is high, 255 is low. The default
is 254.
Switch configuration description. The configuration
description can be up to 32 characters excluding #,
semicolon (;), and comma (,). The default is
Config Default.
A – Command Line Interface
Set Config Command
Description
A-65