Set Config Switch - Qlogic SANbox 5802V Interface Manual

A

Set Config Switch

Sets the switch configuration parameters. The changes you make with this
command are not retained when you reset or power cycle the switch unless you
save them using the
Authority
Admin session and a Config Edit session
Syntax
set config switch
This command initiates an editing session in which to change switch configuration
settings. The system displays each parameter one line at a time and prompts you
for a value. For each parameter, enter a new value or press the Enter key to
accept the current value shown in brackets.
configuration parameters.
AdminState
BroadcastEnabled
InbandEnabled
FDMIEnabled
FDMIEntries
DefaultDomainID
DomainIDLock
SymbolicName
59263-01 A
Config
Table 14-22. Switch Configuration Parameters
Parameter
Switch administrative state.
Broadcast. Enables (True) or disables (False) forwarding of
broadcast frames. The default is True.
Inband management. Enables (True) or disables (False) the
ability to manage the switch over an ISL. The default is True.
Fabric Device Monitoring Interface. Enables (True) or dis-
ables (False) the monitoring of target and initiator device
information. The default is True.
The number of device entries to maintain in the FDMI data-
base. Enter a number from 0–1000. The default is 1000.
Default domain ID. The default is 1.
Prevents (True) or allows (False) dynamic reassignment of
the domain ID. The default is False.
Descriptive name for the switch. The name can be up to 32
characters excluding #, semicolon (;), and comma (,). The
default is SANbox.
Save command.
Table 14-22
Description
Online – Activates and prepares the ports to send data.
This is the default.
Offline – Prevents the ports from receiving signal and
accepting a device login.
Diagnostics – Prepares the ports for testing and prevents
the ports from accepting a device login.
Down – Disables the ports by removing power from the
port lasers.
14 – Command Reference
Set Config Switch
describes the switch
14-95