B-8 Set Config Switch Parameters - Qlogic SANbox2-16 Fibre Channel Installation Manual


switch
Initiates an editing session in which to change switch configuration settings. The
system displays each parameter one line at a time and prompts you for a value.
For each parameter, enter a new value or press the Enter key to accept the
current value shown in brackets.
AdminState
BroadcastEnable
InbandEnabled
DefaultDomainID
DomainIDLock
SymbolicName
R_T_TOV
R_A_TOV
E_D_TOV
FS_TOV
DS_TOV
59021-05 A
Table B-8. Set Config Switch Parameters
Parameter
B – Command Line Interface
Set Config Command
Description
Switch administrative state: online,
offline, or diagnostics
Enables (True) or disables (False)
forwarding of broadcast frames.
Enables (True) or disables (False) the
ability to manage the switch over an
ISL.
Default domain ID setting
Prevents (True) or allows (False)
dynamic reassignment of the
domain ID.
Descriptive name
Receiver Transmitter Timeout Value.
Specifies the number of milliseconds a
port is to wait to receive a response
from another port. The default is 100.
Resource Allocation Timeout Value.
The number of milliseconds the switch
waits to allow two ports to allocate
enough resources to establish a link.
The default is 10000.
Error Detect Timeout Value. The
number of milliseconds a port is to wait
for errors to clear. The default is 2000.
Fabric Stability Timeout Value. The
default is 5000 msec.
Distributed Services Timeout Value
(Management Server, Name Server).
The default is 5000 msec.
B-27