Qlogic SANbox 5602 User Manual page 269

0
LIP_F8_AL_PS
LIP_F7_F7
LIP_F8_F7
Link Failures
Login
Logout
LoopTimeouts
LossOfSync
PrimSeqErrors
RxLinkResets
RxOfflineSeq
TotalErrors
TotalLIPsRecvd
TotalLIPsXmitd
TotalLinkResets
TotalOfflineSeq
TotalRxFrames
TotalRxWords
59097-01 A
Table A-27. Show Port Parameters (Continued)
Entry
This LIP denotes a loop failure detected by the L_Port
identified by AL_PS.
A loop initialization primitive frame used to acquire a valid
AL_PA.
A loop initialization primitive frame used to indicate that a loop
failure has been detected at the receiver.
Number of optical link failures detected by this port. A link
failure is a loss of synchronization or a loss of signal while not
in the offline state. A loss of signal causes the switch to attempt
to re-establish the link. If the link is not re-established, a link
failure is counted. A link reset is performed after a link failure.
Number of device logins
Number of device logouts
A two (2) second timeout as specified by FC-AL-2.
Number of synchronization losses (>100 ms) detected by this
port. A loss of synchronization is detected by receipt of an
invalid transmission word.
Primitive sequence errors detected.
Number of link reset primitives received from an attached
device.
Number of offline sequences received. An OLS is issued for
link initialization, a Receive & Recognize Not_Operational
(NOS) state, or to enter the offline state.
Total number of errors detected.
Number of loop initialization primitive frames received by this
port.
Number of loop initialization primitive frames transmitted by
this port.
Total number of link reset primitives.
Total number of Offline Sequences issued and received by this
port.
Total number of frames received by this port.
Total number of words received by this port.
A – Command Line Interface
Show Command
Description
A-95