Qlogic SANbox 5602 User Manual page 220

A – Command Line Interface
Reset Command
security
Clears the security database and deactivates the active security set. The security
configuration value, autosave, and fabric binding remain unchanged.
services
Resets the switch services configuration to the default values as described in
Table A-15.
snmp
Resets the SNMP configuration settings to the factory default values. Refer to
Table A-13
switch
Resets the switch without a power-on self test. This is the default. This reset
disrupts traffic and does the following:
Activates the pending firmware.
Closes all management sessions.
Clears the event log. To save the event log before resetting, refer to the
Log Command" on page
To reset the switch with a power-on self test, refer to the
page A-33. To reset the switch without disrupting traffic, refer to the
Command" on page
system
Resets the system configuration settings to the factory default values. as
described in
Note:
zoning
Clears the zoning database and deactivates the active zone set. The zoning
configuration values (autosave, default visibility) remain unchanged.
A-46
for SNMP configuration default values.
A-75.
A-36.
Table A-16.
Because this keyword changes network parameters, the
workstation could lose communication with the switch.
This keyword does not affect installed license keys.
0
"Set
"Hardreset Command" on
"Hotreset
59097-01 A