Qlogic SANbox 5602 User Manual page 240

A – Command Line Interface
Set Config Command
InteropMode
LegacyAddressFormat
A-66
Table A-20. Set Config Switch Parameters (Continued)
Parameter
Propagates just the active zone set throughout the
fabric (Standard, FC-SW-2 compliant) or the entire
zoning database (Interop-1, non-compliant). The
default is Standard.
Available only when the InteropMode parameter is
Interop-1, this parameter enables (True) or disables
(False) the use of legacy address formatting for
interoperating with non-FC-SW-2 switches. The
default is False.
Description
59097-01 A
0