Qlogic SANbox 5602 User Manual page 237

0
Parameter
AutoPerfTuning
LCFEnable
MFSEnable
VIEnable
MSEnable
NoClose
(1-Gbps/2-Gbps ports
only)
59097-01 A
Table A-18. Set Config Port Parameters (Continued)
Automatic performance tuning for FL_Ports only. The default
is True.
If AutoPerfTuning is enabled (True) and the port is an
FL_Port, MFSEnable is automatically enabled.
LCFEnable and VIEnable are overridden to False.
If AutoPerfTuning is disabled (False), MFSEnable,
LCFEnable, and VIEnable retain their original values.
Link control frame preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True) or
disables (False) preferred routing of frames with R_CTL =
1100 (Class 2 responses). The default is False. Enabling
LCFEnable will disable MFSEnable.
Multi-Frame Sequence bundling. This parameter appears
only if AutoPerfTuning is False. Prevents (True) or allows
(False) the interleaving of frames in a sequence. The default
is False. Enabling MFSEnable disables LCFEnable and
VIEnable.
Virtual Interface (VI) preference routing. This parameter
appears only if AutoPerfTuning is False. Enables (True) or
disables (False) VI preference routing. The default is False.
Enabling VIEnable will disable MFSEnable.
Management server enable. Enables (True) or disables
(False) management server on this port. The default is True.
Loop circuit closure prevention. Enables (True) or disables
(False) the loop's ability to remain in the open state
indefinitely. True reduces the amount of arbitration on a loop
when there is only one device on the loop. The default is
False.
A – Command Line Interface
Set Config Command
Description
A-63