Set Config Switch Parameters - Qlogic SANbox 5200 Series User Manual

A
AdminState
BroadcastEnabled
InbandEnabled
FDMIEnabled
FDMIEntries
DefaultDomainID
DomainIDLock
SymbolicName
R_A_TOV
E_D_TOV
PrincipalPriority
ConfigDescription
59056-03 C
Table A-20. Set Config Switch Parameters
Parameter Description
Switch administrative state: online, offline, or
diagnostics. The default is Online.
Broadcast. Enables (True) or disables (False)
forwarding of broadcast frames. The default is
True.
Inband management. Enables (True) or disables
(False) the ability to manage the switch over an
ISL. The default is True.
Fabric Device Monitoring Interface. Enables (True)
or disables (False) the monitoring of target and
initiator device information. The default is True.
The number of device entries to maintain in the
FDMI database. Enter a number from 0–1000. The
default is 1000.
Default domain ID. The default is 1.
Prevents (True) or allows (False) dynamic
reassignment of the domain ID. The default is
False.
Descriptive name for the switch. The name can be
up to 32 characters excluding #, semicolon (;), and
comma (,). The default is SANbox.
Resource Allocation Timeout Value. The number
of milliseconds the switch waits to allow two ports
to allocate enough resources to establish a link.
The default is 10000.
Error Detect Timeout Value. The number of
milliseconds a port is to wait for errors to clear. The
default is 2000.
The priority used in the FC-SW-2 principal switch
selection algorithm. 1 is high, 255 is low. The
default is 254.
Switch configuration description. The configuration
description can be up to 32 characters excluding
#, semicolon (;), and comma (,). The default is
Config Default.
A – Command Line Interface
Set Config Command
A-65