Qlogic SANbox 5602 User Manual page 270

A – Command Line Interface
Show Command
TotalTxFrames
TotalTxWords
TxLinkResets
TxOfflineSeq
post log
Displays the Power On Self Test (POST) log which contains results from the most
recently failed POST.
setup [option]
Displays setup attributes for the system, SNMP, and the switch manufacturer.
Refer to the
steering [domain_id]
Displays the routes that data takes to the switch given by [domain_id]. If you omit
[domain_id], the system displays routes for all switches in the fabric.
support
Executes a series of commands that display a complete description of the switch,
its configuration, and operation. The display can be captured from the screen and
used for diagnosing problems. This keyword is intended for use at the request of
your authorized maintenance provider. The commands that are executed include
the following:
Alias List
Config List
Date
Group List
History
Ps
Security (List, Limits, History)
Securityset (Active, List)
Show (About, Alarm, Backtrace, Chassis, Config Port, Config Security,
Config Switch, Config Threshold, Dev, Dev Settings, Domains, Donor,
Fabric, Log, Log Archive, Log Settings, Lsdb, Mem, Ns, Perf, Port, Setup
Mfg, Setup Snmp, Setup System, Steering, Switch, Topology, Users)
Uptime
User Accounts
A-96
Table A-27. Show Port Parameters (Continued)
Entry
Total number of frames issued by this port.
Total number of words issued by this port.
Number of Link Resets issued by this port.
Total number of Offline Sequences issued by this port.
"Show Setup Command" on page
Description
A-114.
0
59097-01 A