Qlogic SANbox 5602 User Manual page 121

0
Common administrative operations that change the fabric include:
Zoning modifications
Adding, moving or removing devices attached to the switch fabric. This
includes powering up or powering down attached devices.
Adding, moving or removing ISLs or other connections.
Management Interfaces:
After an NDCLA operation is complete, management connections must be
re-initiated:
SANsurfer Switch Manager sessions will re-connect automatically
Telnet sessions must be restarted manually.
Applicable Code Versions:
Future switch code releases will be upgraded non-disruptively unless
specifically indicated in its associated release notes
An NDCLA operation to previous switch code releases is not supported.
Hot Reset
Reset without
POST
Hard Reset
To reset a switch using SANsurfer Switch Manager, do the following:
1. Select the switch to be reset and open the faceplate display.
2. Open the Switch menu and select the Reset Switch pull-down menu:
59097-01 A
Table 4-3. Switch Resets
Type
Resets a switch without a power-on self test. This reset activates
the pending firmware, but does not disrupt switch traffic. If errors
are detected on a port during a hot reset, the port is reset
automatically.
Resets a switch without a power-on self test. This reset activates
the pending firmware and it is disruptive to switch traffic.
Resets a switch with a power-on self test. This reset activates the
pending firmware and it is disruptive to switch traffic.
Select Hot Reset to perform a hot reset.
Select Reset to perform a standard reset.
Select Hard Reset to perform a hard reset.
4 – Managing Switches
Resetting a Switch
Description
4-17