Table of Contents
Advertisement
Executing and Saving Effects
Run Mode Settings
Executing an effect repeatedly
To execute the same effect repeatedly, use the following procedure.
1
2
3
Executing an effect without cross-point changes
Key frames normally include cross-point selection information, but if you set
F1 (XPT DSBL) in the RUN MODE menu to "ON", the effect is executed
with the current input signal selection state unchanged.
8-28
Chapter 8 Key Frame Effects
In the KEY FRAME menu (see page 8-32), press F4 (RUN MODE).
The RUN MODE menu appears.
RUN MODE
END
XPT
DSBL
LOOP
TIME
OFF
OFF
SAME
F1
F2
F3
Function key indications in the RUN MODE menu
Set F2 (LOOP) to "ON".
Press the RUN button to execute the effect.
The effect execution loops around from the last key frame to the first key
frame, and repeats the effect indefinitely.
There is no interpolation between the last key frame and the first key
frame. If the REV button is lit, the effect is repeated in the reverse
direction.
To stop the repeated execution, set F2 (LOOP) to "OFF", or press the
REWIND button.
F4
F5
F6
F7
KF
FADER
ENBL
F8
F9
F10
Advertisement
Table of Contents
