Sony DVS-7250 User Manual page 348

Setup Relating to Interfaces With Peripheral Devices
(PERIPH Menu)
Carrying out setup relating to auxiliary bus control from an RS-
422A port of the switcher (AUX CONTROL menu)
13-38
Chapter 13 Setup
2
Press F2 (PORT SELECT) or turn control knob 2 to move the cursor and
select EDITOR A/REMOTE 1 or EDITOR B/REMOTE 2 as the port to
which the setting applies.
3
Press F7 (PERIPH SELECT) or turn control knob 3 to move the cursor
and select the connected device.
4
Press F5 (SELECT) to confirm the selection.
You can use the AUX CONTROL menu for the following settings.
• Setting the control function for bus control from an RS-422A port:
For the control of the bus outputs from each of the following switcher
ports, select ENBL (control enabled), DSBL (control disabled) or
MANUAL (status determined by the ENABLE menu setting (see page
12-3)).
PANEL 1, DME 1 to DME 4, EDITOR A/REMOTE 1, EDITOR B/
REMOTE 2, PANEL 2
• Selecting the function setting for recalling auxiliary bus settings when
executing a key frame or snapshot: Select whether when executing a
key frame or snapshot to recall the saved auxiliary bus settings (ENBL)
or keep the current settings unchanged (DSBL).
To carry out these settings, use the following procedure.
1
In the PERIPH menu, press F4 (AUX CTRL).
The AUX CONTROL menu appears.
BUS
PANEL DME1
SELECT
#2
ENBL ENBL
F1 F2 F3
Function key indications in the AUX CONTROL menu
2
Press F1 (BUS SELECT) or turn control knob 2 to move the cursor and
select the bus to which the settings apply from buses AUX 1 to AUX 13
or the edit preview (EDIT PVW) bus.
DME2 DME4 EDIT A
DME3
ENBL ENBL ENBL ENBL
F4 F5 F6 F7
KF/
EDIT B PANEL2 SS
ENBL ENBL ENBL
F8 F9 F10