Table of Contents
Advertisement
Setup Relating to Operations From the Control Panel
(OPERATION Menu)
13-56
Chapter 13 Setup
6
Press F2 (SOURCE SELECT) or turn control knob 2 to move the cursor
and select the signal to which you wish to assign a name.
7
Either press F8 (NAME SELECT) or turn control knob 3 to move the
cursor; or either press F9 (USER NAME SELECT) or turn control knob
4 to move the cursor, and then select the required signal name.
To enter a new signal name
In the list of example signal names, select USER.
8
Press F6 (SELECT).
When you have selected a signal name attached with "?" in step 7,
further specify the required number and press the ENTER button.
• If you selected USER in step 7, a text input screen appears. In this
case, advance to step 9.
• In other cases, the name selection is confirmed.
9
Using the keyboard displayed on the screen and the numeric keys in the
numeric keypad section, enter a name of up to eight characters, and press
the F9 (ENTER) or the ENTER button in the numeric keypad section to
confirm the name.
For details of the input method, see page 3-11.
To create or change the signal name selected with F9 (USER
NAME SELECT)
Use the following procedure.
1
Press F10 (SET USER NAME).
A text input screen appears.
2
Press F2 (SELECT) or turn control knob 2 to move the cursor and select
free space for creating a new signal name or select the existing signal
name to be corrected.
3
Enter a new signal name as in step 9 of the foregoing procedure.
To enable the setting of a signal name using steps 7 and 8 of the
foregoing procedure, press F6 (?) to postfix "?" to the signal name.
Advertisement
Table of Contents
