Table of Contents
Advertisement
Menu
GPI INPUT
GPI OUTPUT
PANEL PORT
ASSIGN
Selecting the type of device connected to an RS-422A port of
the switcher (PORT ASSIGN menu)
You can use the PORT ASSIGN menu to select the type of device connected
to an RS-422A port of the switcher.
Select the type of device from the following.
To carry out these settings, use the following procedure.
1
In the PERIPH menu, press F3 (PORT ASSIGN).
The PORT ASSIGN menu appears.
F1
Menus accessed from the PERIPH menu (Continued)
Functions
Making the following settings relating to
switcher GPI inputs
• Selecting the trigger polarity
• Selecting the trigger action
Making the following settings relating to
switcher GPI outputs
• Selecting the operation to cause the
GPI output
• Making the trigger selection
Making the following settings for the
control panel communication ports
• Setting protocol for the control panel
REMOTE2 port
• Switching between GPI output ports
and 9-pin ports
• GPI output port settings
When the port is EDITOR A/REMOTE 1: editor A or a remote
control panel
When the port is EDITOR B/REMOTE 2: editor B or a remote
control panel
PORT
SELECT
#2
F2
F3
F4
Function key indications in the PORT ASSIGN menu
Function key
F7 (GPI
INPUT)
F8 (GPI
OUTPUT)
F9 (PANEL
PORT)
PERIPH
SELECT
SELECT
#3
F5
F6
F7
See page
13-45
13-47
13-49
F8
F9
F10
(Continued)
Chapter 13 Setup
13-37
Advertisement
Table of Contents
