Sony DVS-7250 User Manual page 163

Setting the transition rate
To set the transition rate in the ALL STATUS menu (see the previous page),
use the following procedure.
1
Press F10 (TRANS RATE).
Alternatively, press the TRANS RATE button in the numeric keypad
section twice in quick succession.
The function key indications change as follows. The indications for F5
to F10 depend on the selections of F1 to F3.
BLOCK SELECT
M/E-1 M/E2 P/P
F1 F2 F3
Function key indications in the ALL STATUS menu
BLOCK SELECT
M/E-1 M/E2 P/P
F1 F2 F3
Function key indications in the ALL STATUS menu (when F3 is selected)
2
Press one of F1 (M/E-1) to F3 (P/P), to select the corresponding block
(bank).
3
• If you pressed F1 or F2 in step 2, now press one of F5 to F7, to select
the transition rate setting from the following:
F5 (AUTO TRANS): The auto transition rate set in the M/E transition
control section
F6 (KEY1 MIX): Mix rate for M/E key 1
F7 (KEY2 MIX): Mix rate for M/E key 2
TRANS RATE
AUTO
KEY 1 KEY 2
TRANS
MIX MIX
F4 F5 F6 F7
(when F1 or F2 is selected)
TRANS RATE
AUTO DSK1 DSK2
TRANS MIX MIX
F4 F5 F6 F7
Chapter 4 Basic Operations for Image Creation
F8 F9 F10
FTB
F8 F9 F10
4-103