Table of Contents
Advertisement
Keys
5
Modifying the key edge
Edge modifications require the optional BKDS-7270 Key Border Board to be
Option
fitted.
Use the following procedure to modify the key edge, for example adding a
border to the M/E-1 key 1.
1
2
4-42
Chapter 4 Basic Operations for Image Creation
If you selected F6 (SPLIT) in step 4, select the key source signal using
the cross-point buttons, as follows.
Press the keyer delegation button KEY 1 in the key control section to
delegate the key control section to keyer 1, then hold down the SPLIT
button and press the required cross-point button in the K1 row (BKDS-
7026)/K row (BKDS-7025) or in the auxiliary bus bank.
When the object of operation is a downstream key (DSK 1 or DSK 2),
holding down the delegation button DSK 1 or DSK 2 in the auxiliary bus
bank, press the required cross-point button.
In the M/E-1 KEY 1 menu, select item 3 (EDGE).
The EDGE menu appears.
EDGE TYPE
DROP
BORDER
BORDER
NORMAL
4H
F1
F2
F3
Function key indications in the EDGE menu
Press one of F1 through F5 to select the edge type.
You can also use the BORD, DROP BORD, SHDW and OUTLINE
buttons in the key control section.
F1 (NORMAL): unmodified edge.
F2 (BORDER): apply a border.
F3 (DROP BORDER): apply a drop border.
F4 (SHADOW): apply a shadow.
F5 (OUTLINE): use the outline function.
If you selected F1 (NORMAL), go to step 5.
4H
OUT
SHADOW
DROP
LINE
ON
F4
F5
F6
EDGE FILL
SOFT
UTILITY
MATTE
EDGE
BUS
MATTE
ADJUST
OFF
OFF
F7
F8
F9
F10
Advertisement
Table of Contents
