Table of Contents
Advertisement
Port Enable Settings
Overview
The port enable function controls the enabling and disabling of ports on the
switcher from external devices. You can make these settings for the
following ports.
Switcher ports:
• GPI (parallel port, D-sub 25-pin)
You can carry out the GPI input/output settings in a setup menu (see pages
13-45 and 13-47).
• DME1 to DME4 (serial, RS-422A, D-sub 9-pin)
• EDITOR A / REMOTE 1 (serial, RS-422A, D-sub 9-pin)
You can specify the device connected to this port in a setup menu (see page
13-37).
• EDITOR B / REMOTE 2 (serial, RS-422A, D-sub 9-pin)
You can specify the device connected to this port in a setup menu (see page
13-37).
• PANEL 2 / REMOTE 3 (serial, RS-422A, D-sub 9-pin)
Note
For the control of the auxiliary buses from ports other than GPI, the setting
(ENBL/DSBL/MANUAL) in the setup menu (see page 13-38) takes
precedence. The MISC menu setting is only effective when this setup menu
item is set to MANUAL.
Chapter 12 MISC Menu Operations
12-3
Advertisement
Table of Contents
