Table of Contents
Advertisement
Setup Relating to the Overall Switcher System (SYSTEM Menu)
3
4
5
Setting the system configuration (SYSTEM CONFIGURATION
menu)
You can use the SYSTEM CONFIGURATION menu for the following
settings.
13-8
Chapter 13 Setup
Press F3 (SIGNAL FORMAT), F4 (7.5 SETUP) or F5 (SCREEN
FORMAT).
The SIGNAL FORMAT menu appears.
FORMAT
D2-525
D1-525
F1
F2
F3
Function key indications in the SIGNAL FORMAT menu
To select a required signal format, press the corresponding function key
(F2, F3 or F4).
Signal format
D2-525
D1-525
D1-625
• To set the screen aspect ratio, press F5 (4:3) or F6 (16:9).
• To toggle the 7.5 IRE setup on or off, press F7 (7.5 SETUP).
In this case, toggling takes place immediately.
Press F10 (EXEC).
If the operation selected in step 4 is changing the signal format, the
system is reset to the state at power on and the signal format is changed.
The new signal format setting is immediately saved in nonvolatile
memory.
If the operation selected in step 4 is changing the screen aspect ratio, the
control panel and DME settings are reset to the state at power on and the
screen aspect ratio changes. The switcher settings are not reset.
• Setting the input signal range: Toggle the input signal range between
WIDE and NARROW. When using switcher outputs as inputs to the
DMK-7000, this setting must be NARROW.
SCREEN
16:9
D1-625
4:3
F4
F5
F6
Function key to press
F2 (D2-525)
F3 (D1-525)
F4 (D1-625)
7.5
SETUP
EXEC
F7
F8
F9
F10
Advertisement
Table of Contents
