Table of Contents
Advertisement
Menu Control Section and Floppy Disk Drive
1 Top menu selection buttons
Each of these buttons accesses a top menu.
For details of the menu names and
functions associated with these buttons,
see page 3-2.
2 Item selection buttons
These five buttons select the items within
a menu. Pressing a button highlights the
item display in reverse video, and changes
the function key indications accordingly.
3 Menu screen
This displays the menu currently in use.
For detailed menu operation, see Chapter
3.
4 Parameter setting section
The controls in this section correspond to
the values of parameters represented by
bar indications at the right side of the
menu screen.
Knobs: Turning a knob adjusts the value
directly. In this manual these are
referred to as knobs 1 through 4 from
the top down.
KEY PAD buttons: Pressing one of
these buttons allows you to enter the
corresponding parameter value from
the numeric keypad.
5 Cursor keys
Press these to change the group of
parameters being adjusted, and also to
move the cursor about the menu screen.
2-28
Chapter 2 Location and Function of Parts
6 EXIT button
Press this button to exit from the currently
displayed menu to its parent menu, or the
previously displayed menu. When a pop-
up appears in the menu screen, this button
also clears the pop-up.
7 Function keys
Function keys F1 to F10 carry out the on/
off or selection operations shown by the
function key indications along the lower
edge of the menu screen.
If there are two indications for a single
function key, hold down the SHIFT button
and press the function key to obtain the
effect of the upper indication.
8 SHIFT button
Use this in conjunction with the function
keys F1 to F10.
9 Floppy disk drive
This takes a 3.5-inch floppy disk. You use
it for installing the operation software, and
for saving snapshot, key frame, setup and
other data on a floppy disk.
The disk drive is controlled by menu
operations.
Advertisement
Table of Contents
