Sony DVS-7250 User Manual page 164

Status Display
4-104
Chapter 4 Basic Operations for Image Creation
• If you pressed F3 (P/P) in step 2, now press one of F5 to F8, to select
the transition rate setting from the following:
F5 (AUTO TRANS): The auto transition rate set in the P/P transition
control section
F6 (DSK1 MIX): Mix rate for DSK 1
F7 (DSK2 MIX): Mix rate for DSK 2
F8 (FTB): The rate set for a fade-to-black in the DSK control section
4
Enter the transition rate (duration) from the numeric keypad, and press
the ENTER button.
Selecting an auxiliary bus signal
To select an auxiliary bus signal in the ALL STATUS menu, use the
following procedure.
1
Press F8 (AUX SELECT).
The function key indications change as follows.
[AUX9] [AUX10] [AUX11]
AUX1 AUX2 AUX3
F1 F2 F3
Function key indications in the ALL STATUS menu (when F8 is selected)
2
Press the function key corresponding to the desired auxiliary bus.
To select AUX9 to ED PVW, press F1 to F6 while holding down the
SHIFT button in the menu control section.
3
Enter the button number corresponding to the desired signal from the
numeric keypad, or use the cursor movement buttons (> . ? /) to
align the cursor with the required signal display, then press F10
(SELECT).
[AUX13]
[AUX12] [ED PVW]
AUX4 AUX5 AUX6 AUX7
F4 F5 F6
AUX8 SELECT
F7 F8 F9 F10