Table of Contents
Advertisement
Overview
It is possible to copy the settings on one M/E bank or keyer to another, or to
swap the settings between a pair of M/E banks or keyers.
There are four different ways you can make a copy or swap to affect different
sets of settings, as follows:
• M/E copy and M/E swap
• Keyer copy and keyer swap
• Wipe copy and wipe swap
• Matte copy and matte swap
M/E copy and M/E swap
Banks copied or swapped
All of the current settings on the M/E-1, M/E-2 and PGM/PST banks are
copied or swapped.
Data not copied or swapped
The following data is not copied or swapped:
• Setup data
• Key memory
Note
When the copy/swap source has chroma key selected as the key type, but a
chroma key is not possible on the destination bank, the key type is not
copied. However, other key data (key edge, etc.) is copied.
Whether or not chroma keying is possible depends on the options (BKDS-
2031/2032) fitted on the destination bank, and the mode setting (single/dual).
For example, for a copy/swap of an enhanced chroma key setting, the
destination bank must have two options installed, and single mode selected.
For details of the chroma key mode, see page 5-2.
11-2
Chapter 11 Copy and Swap Operations
Advertisement
Table of Contents
