Working Inside The Portserver Cm - Digi PortServer CM User Manual

stepped on or tripped over.
• Do not spill food or liquids on your PortServer CM. If it gets wet, contact Digi Technical Support.
• Do not push any objects into the openings of your PortServer CM. Doing so can cause fire or electric
shock by shorting out interior components.
• Keep your PortServer CM away from heat sources. Also, do not block cooling vents.

Working Inside the PortServer CM

NOTICE: Do not attempt to service the PortServer CM yourself, except following the instructions from
Digi Technical Support personnel. In such a case, first perform the following actions:
• Turn off the PortServer CM.
• Ground yourself by touching an unpainted metal surface at the back of the equipment before touching
anything inside your equipment.
Replacing the Battery
A coin-cell battery maintains date and time information. If you have to repeatedly reset time and date
information after turning on your PortServer CM, replace the battery.
CAUTION: A new battery can explode if it is incorrectly installed. Replace the 3 Volt CR2032 battery
only with the same or equivalent type recommended by the battery manufacturer. Discard used
batteries according to the battery manufacturer's instructions.
Introduction
1-3