Removing The Rear Two Hard-Disk-Drive Kit - Lenovo System x3650 M5 Installation And Service Manual

2. Make sure the wire cables are routed in the proper locations without blocking the retention
brackets installation.
Step 9. Reinstall the top cover (see "Replacing the top cover" on page 164).
Step 10. Slide the server into the rack.
Step 11. Reconnect the power cords and all external cables, and turn on the server and peripheral devices.

Removing the rear two hard-disk-drive kit

Use this information to remove the rear two hard-disk-drive kit.
See http://www.lenovo.com/ serverproven/
To remove the rear two hard-disk-drive kit, complete the following steps:
Step 1. Read the safety information that begins on page "Safety" on page v and "Installation guidelines" on
page 305.
Step 2. Turn off the server and peripheral devices, and disconnect the power cord and all external cables.
Step 3. Remove the top cover (see "Removing the top cover" on page 162).
Step 4. Grasp the kit at the front and the rear edge and lift it up to remove from the server. Place the kit on
a flat, static-protective surface.
• 2.5-inch rear two hard-disk-drive kit removal
Figure 145. 2.5-inch rear two hard-disk-drive kit removal
• 3.5-inch rear two hard-disk-drive kit removal
218
Lenovo System x3650 M5 Installation and Service Guide
for a list of hard disk drives that you can use with the server.
2.5-inch rear two
hard-disk-drive kit 1