Lenovo System x3650 M5 Installation And Service Manual page 325

2.5-inch HDD hot-swap
backplane (expander)
Figure 277. Backplane installation
Step 8. Connect SAS signal and power/configuration cables to the backplane and the system board as the
following illustrations.
• If the new backplane is installed in slot 2, route cables as the following illustration.
Note: Use right angleMini-SAS HD Y-cable to connect to PCI expansion slots 4.
2.5-inch HDD hot-swap backplane
SAS 1
SAS signal cable
Figure 278. Cable connections
1
2
1
2.5-inch HDD hot-swap backplane
Power / configuration cable
2.5-inch HDD hot-swap backplane
SAS 0
SAS 1
SAS signal cable
2
Power / configuration cable
SAS 0
.
Chapter 5 Installing, removing, and replacing components
313