Star Micronics Line Thermal Printer Specifications page 55

ESC FS p n m
[Name] Print logo
[Code] ASCII ESC
Hex. 1B
Decimal 27
[Defined Area] 1≤n≤255
0≤m≤3
48≤m≤51 ("0"≤m≤"3")
[Initial Value] - - -
[Function] Prints the logo of registration number n registered using the logo registration command (ESC FS q)
according to the print mode m.
m Logo print mode
0, 48 Normal mode
1, 49 Double wide mode
2, 50 Double high mode
3, 51 Double high/wide mode
If there is unprinted data in the line buffer, this command is executed after printing that data.
Therefore, it is not possible to print with other data in the same line (characters, bit images, bar
codes).
Form feed obeys the vertical print size of the logo.
If the logo horizontal print size exceeds the horizontal print region, the portion exceeding the area
is not printed.
Logos are printed according to the following command settings.
• Left margin (ESC I n)
• Right margin (ESC Q n)
• Position alignment (ESC GS a n)
• Absolute position movement (ESC GS A n1 n2)
• Relative position movement (ESC GS R n1 n2)
• Upside-down printing (SI)
ESC RS L m
[Name] Spec. A Print logo in batch
Spec. B Batch control of registered logos
[Code] ASCII ESC RS
Hex. 1B
Decimal 27
[Defined Area] Spec. A
Spec. B
[Initial Value] - - -
[Function] Spec. A
reset after printing.
Spec. B
After execution, this resets the printer.
Spec. A
m Logo print mode
0, 48 Normal mode
1, 49 Double wide mode
2, 50 Double high mode
3, 51 Double high/wide mode
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
FS p n m
1C 70 n m
28 112 n m
L m
1E 4C m
30 76 m
0 ≤ m ≤ 3 48 ≤ m ≤ 51 ("0" ≤ m ≤ "3")
0 ≤ m ≤ 3 48 ≤ m ≤ 51 ("0" ≤ m ≤ "3"),m=255
Prints all registered logos according to a print mode specified by m. Executes a printer
Controls logos as specified by the parameter m.
3-39