Star Micronics Line Thermal Printer Specifications page 120

ESC GS / W
[Name] Register Auto Logo setting to non-volatile memory
[Code] ASCII ESC GS
Hex.
Decimal
[Defined Area] - - -
[Initial Value] - - -
[Function] Registers Auto Logo setting to non-volatile memory
After registration, the printer is reset.
This command is ignored when Auto Logo is being executed.
ESC GS / C
[Name] Initialize Auto Logo setting to non-volatile memory
[Code] ASCII ESC GS
Hex.
Decimal
[Defined Area] - - -
[Initial Value] - - -
[Function] Initializes registered data in the non-volatile memory of the Auto Logo function.
After initialization, the printer is reset.
This command is ignored when Auto Logo is being executed.
The default values of the Auto Logo function are below.
Setting
Auto Logo Function
Command Character
User Macro 1
User Macro 2
Command Character Switch
Partial Cut Before Auto Logo Printing
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
/ W
1b 1d 2f 57
27 29 47 87
/ C
1b 1d 2f 43
27 29 47 67
3-104
Initial Value
OFF
None
None
None
No print
Disabled