Star Micronics Line Thermal Printer Specifications page 159

• TSP700II
Mai n tenance
Counter Type
Permanent Head
Counter Energizing
Count
LF
Traveling
Distance
Cutter Drive
Count
User Counter Head
Energizing
Count
LF
Traveling
Distance
Cutter Drive
Count
• The head energizing count is sometimes counted even when there is not energizing data. (Such as when
blank space data is included in the font data.)
• The estimated life prescribes the number of count of the maintenance counter. It does not match the life
specifications.
• When the permanent counter exceeds the counter maximum value, thereafter the permanent counter
and user counter both count up and then stop.
• It is possible to clear the user counter, but it is not possible to clear the permanent counter.
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
Esti m ated Li f e
Counter
800 Million
dot lines
Motor 100 km; 800
Million dot
lines
200,000 cuts
800 Million
dot lines
Motor 100 km; 800
Million dot
lines
200,000 cuts
5-18
Count Up
Counter
Predetermined
Maxi m um Value
Ti m es
For each 0xF4240 (1
4,000 dot Million)
lines (500
mm)
For each 0xF4240 (1
4,000 dot Million)
lines (500
mm)
Every 10 cuts 0xF4240 (1
Million)
For each 0xF4240 (1
4,000 dot Million)
lines (500
mm)
For each 0xF4240 (1
4,000 dot Million)
lines (500
mm)
Every 10 cuts 0xF4240 (1
Million)
EEPROM Wri t ing Ti m ing
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
• When cutting paper
• Every 10 minutes (when idling) from
when power is turned on. However, one
condition is that the
predetermined count is exceeded.
count up
count up
count up
count up
count up
count up