Star Micronics Line Thermal Printer Specifications page 152

<Printer status 6 ETB Counter (Eighth Byte)>
Bit Contents
7 Fixed at 0
6 ETB Counter Bit-4
5 ETB Counter Bit-3
4 Fixed at 0
3 ETB Counter Bit-2
2 ETB Counter Bit-1
1 ETB Counter Bit-0
0 Fixed at 0
(*) ETB Counter
This counter is the 5 bit ETB counter.
(It counts from 0 to 31. When the counter overflows, it counts up from 31 to 0.)
This counter is incremented by 1 using the <ETB> command.
The ETB counter is initialized by the following commands. When doing so, ASB ETB status is cleared.
However, when initializing the ETB counter, ASB is not transmitted.
<ETB Counter Initialization Commands>
• <ESC> <RS> E n
• <CAN>
―――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――――
STAR Line Mode Command Specifications
Status
TSP800
"0" "1"
V. 4.0 or later
-
OK
OK
-
OK
OK
OK
-
: ETB Counter Initialization
: Cancel print data and initialize commands
5-11
Model Compatability
TSP700 TSP600 TUP900
V. 3.0 or V. 3.0 or
later later
- - -
OK OK
OK OK
- - -
OK OK
OK OK
OK OK
- - -
TSP1000 TSP828L TSP700II TSP650
- - -
OK OK OK
OK OK OK
- - -
OK OK OK
OK OK OK
OK OK OK
- - -
- -
OK OK
OK OK
- -
OK OK
OK OK
OK OK
- -