Figure 37. Data Dependent Nl Ms3 Template - Thermo Scientific ETD Getting Started Manual

Thermo Scientific
7. Click OK to open the Data Dependent NL MS3 template

Figure 37. Data Dependent NL MS3 template

8. Enter the scan event settings by clicking the Scan Event 1, Scan Event 2, and
Scan Event 3 bars.
For Scan Event 2 and Scan Event 3, the Dependent Scan check box (lower left corner)
and its adjacent Settings button become active.
9. (For Scan Event 2 and Scan Event 3 only) Click Settings to open the Data Dependent
Settings dialog box (Figure 33
10. In the left pane, under the Scan Event list, click Activation to see the activation
parameters (Figure 34
The activation type is automatically set to ETD.
11. In the Default Charge State box, enter a value of 5 or more.
6
on page 46).
on page 46).
Running an Xcalibur Experiment by Using ETD
Data Dependent NL MS
(Figure 37).
MS/ETD System Getting Started Guide
3
Experiment
49