Performing An Etd Infusion Experiment; Viewing The Injection Reagent Settings; Figure 21. Ion Trap Page In The Injection Control Dialog Box - Thermo Scientific ETD Getting Started Manual

Performing an ETD Infusion Experiment

Viewing the Injection Reagent Settings

Thermo Scientific
This chapter discusses the ETD infusion experiment.
• Viewing the Injection Reagent Settings
• Troubleshooting an AGC Target Error
• Obtaining an ETD Spectrum for Angiotensin I
• Optimizing the Reagent Ion Reaction Time
The parameters on the Reagent page in the Injection Control dialog box
the number of reagent ions admitted into the ion trap of the LTQ XL or LTQ Velos MS
detector
 To view the injection reagent ion settings
1. Open the Tune Plus window; see the instructions on
2. Choose Setup > Injection Control to open this dialog box

Figure 21. Ion Trap page in the Injection Control dialog box

(Figure 22) regulate
page 13.
(Figure 21).
MS/ETD System Getting Started Guide
5
33