Table of Contents
Advertisement
Example 2:
enableoutput device "/mod4B", mode "always"
Remarks:
The enableoutput mode argument determines the clock
qualifier used for vector driving. If the "always" mode is
selected, all clocks are qualified to drive out vectors. If
the "high" or "low" mode is selected, the appropriate
level must be present on the external ENABLE line to
qualify the clock. This command only qualifies the clock
when the syncoutput mode is "drclk" or "intfreq". Both
syncoutput modes "int" and "pod" clocks are always
qualified.
Related Commands:
edgeoutput, syncoutput, vectordrive
For More Information:
• The "Overview Of TL/1" section of the Programmer's
enableoutput-2
Manual.
Advertisement
Table of Contents
