Table of Contents
Advertisement
Example 2:
syncoutput device "/mod2", mode "pod"
syncoutput device "/mod1", mode "drclk"
vectordrive device "/mod1, /mod2"
Remarks:
When the syncoutput mode is set to "pod", use the sync
command to select either pod address, pod data, or an-
other pod sync mode as the clock source.
When the syncoutput mode is set to "intfreq", use the
clockfreq command to control the frequency of the clock.
When the syncoutput mode is set to "int", use the
strobeoutclock command to clock out the vectors.
Related Commands:
clockfreq, edgeoutput, enableoutput, strobeoutclock,
sync, vectordrive
For More Information:
• The "Overview Of TL/1" section of the Programmer's
syncoutput-2
Manual.
Advertisement
Table of Contents
