Table of Contents
Advertisement
•
F5 - Cut
Deletes the marked block from the display and moves it
into one of the temporary buffers. This softkey does not
appear until a Mark has been set. See the 9100 Series
Programmer's Manual for more information.
•
F6 - Yank
Copies the marked block into one of the temporary buffers,
but does not remove the block from the display. This
softkey does not appear until a Mark has been set. See the
9100 Series Programmer's Manual for more information.
•
F7 - Paste
Copies the contents of one of the temporary buffers into the
display just before the cursor position. See the 9100 Series
Programmer's Manual for more information.
•
F8 - Replace
Moves the cursor to and replaces the next occurrence of a
character string you have specified. See the 9100 Series
Programmer's Manual for more information.
•
F9 - Search
Moves the cursor to the next occurrence of a character
string you have specified. See the 9100 Series
Programmer's Manual for more information.
•
F10 - Check
Performs an overall check of the vector file by searching
for syntax errors that cannot be detected by the line-
checker. See the 9100 Series Programmer's Manual for
more information.
9100A-017
6-3
Advertisement
Table of Contents
