Juniper SRX100 Hardware Manual page 55

Preparing the SRX100 Services Gateway for Wall-Mount Installation
You can mount an SRX100 Services Gateway on a wall. The four rubber feet attached
to the chassis provide stability.
Before mounting an SRX100 Services Gateway on a wall:
NOTE: The wall-mounting kit is not shipped with the device and must be ordered
separately.
Related Topics
Verify that the site meets the requirements described in "Site Preparation
Checklist for the SRX100 Services Gateway" on page 17.
Remove the services gateway chassis from the shipping carton. For unpacking
instructions, see "Unpacking the SRX100 Services Gateway" on page 31.
Verify that you have the following parts available in your wall-mounting kit for
the SRX100 Services Gateway:
Wall-mounting brackets
Screws
Site Preparation Checklist for the SRX100 Services Gateway on page 17
Unpacking the SRX100 Services Gateway on page 31
Clearance Requirements for Airflow and Hardware Maintenance of the SRX100
Services Gateway on page 22
Preparing the SRX100 Services Gateway for Rack-Mount Installation on page 35
Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 36
Preparing the SRX100 Services Gateway for Wall-Mount Installation
Chapter 7: Preparing the SRX100 Services Gateway for Installation
37