Juniper SRX100 Hardware Manual page 102

SRX100 Services Gateway Hardware Guide
Monitoring the SRX100 Services Gateway Power System
The LEDs on the services gateway enable you to determine the performance and
operation. The Power LED, located on the front panel of the services gateway,
indicates the different settings with respect to the power system.
Table 31 on page 84 describes different Power LED status settings and their corrective
actions.
Table 31: Services Gateway Power LED Status
LED Status
Green
Amber
Off
Related Topics
84
Monitoring the SRX100 Services Gateway Power System
Using the Reset Config Button on the SRX100 Services Gateway on page 85
Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 86
Juniper Networks Technical Assistance Center on page 87
Meaning
Device is receiving power, and the
internal power supply is functional.
Indicates that the power button has
been pressed and quickly released.
Indicates that the device is not
receiving power.
Monitoring the SRX100 Services Gateway Chassis Using the CLI on page 79
Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
Using the Reset Config Button on the SRX100 Services Gateway on page 85
Changing the Reset Config Button Behavior on the SRX100 Services Gateway on
page 86
Juniper Networks Technical Assistance Center on page 87
Possible Cause and Corrective Action
Normal indication. No action is required.
Normal indication. No action is required.
Verify that the AC power cord from the power
source to the device is not damaged. If the
insulation is cracked or broken, immediately
replace the cord or cable.
Ensure that the socket you plug in is in
working condition.
Ensure the device has an AC input voltage
between 100 and 240 VAC.
If you cannot determine the cause of the
problem or need additional assistance, see
"Juniper Networks Technical Assistance
Center" on page 87.