Installing The Srx100 Services Gateway On A Wall - Juniper SRX100 Hardware Manual

2.
3.
Related Topics

Installing the SRX100 Services Gateway on a Wall

You can install the SRX100 Services Gateway on a wall. The device is shipped with
the rubber feet attached. The rubber feet help stabilize the device on the wall and
enhance airflow.
NOTE: The wall-mounting kit is not shipped with the device and must be ordered
separately.
To install the device on a wall:
1.
2.
Figure 9: Installing the SRX100 Services Gateway on a Wall
3.
Attach the vertical stand to the right side of the chassis as shown in Figure 8 on
page 42.
Place the chassis vertically on the desk with the stand resting on the desk.
Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway on page 29
Preparing the SRX100 Services Gateway for Desk-Mount Installation on page 36
SRX100 Services Gateway Safety Requirements, Warnings, and Guidelines on
page 39
Installing the SRX100 Services Gateway in a Rack on page 40
Installing the SRX100 Services Gateway on a Wall on page 43
Place the device on a flat and level surface with the Juniper Logo facing up. Turn
the chassis upside down on a desk or work surface where you intend to operate
the device.
Position a mounting bracket on each side of the chassis as shown in Figure 9 on
page 43.
Use a number–2 Phillips screwdriver to install the screws that secure the
mounting brackets to the chassis.
Chapter 8: Installing the SRX100 Services Gateway
Installing the SRX100 Services Gateway on a Wall
43