Using The Reset Config Button On The Srx100 Services Gateway - Juniper SRX100 Hardware Manual

Related Topics
Monitoring the SRX100 Services Gateway Components Using LEDs
Table 28 on page 81 describes the status of the LEDs on start up of the device.
Table 28: Services Gateway LED Status on Startup
LED
Status LED
Alarm LED
Power LED
HA LED
NOTE: Chassis clustering is not supported in this release.
The LEDs available on the services gateway display the status of various components.
Table 29 on page 82 describes the LEDs.
Monitoring the SRX100 Services Gateway Components Using LEDs on page 81
Monitoring the SRX100 Services Gateway Using Chassis Alarm Conditions on
page 83
Monitoring the SRX100 Services Gateway Power System on page 84
Maintaining the SRX100 Services Gateway Hardware Components on page 77
Using the Reset Config Button on the SRX100 Services Gateway on page 85
Juniper Networks Technical Assistance Center on page 87
State
Amber
Amber
Green
Off
Monitoring the SRX100 Services Gateway Components Using LEDs
Chapter 14: Monitoring the SRX100 Services Gateway
Description
Indicates that the device is starting up.
Indicates that the device is starting up for the first
time since no rescue configuration is set.
Indicates that the device is receiving normal power
supply.
Indicates that the device is not part of chassis
clustering set up.
81