Juniper SRX100 Hardware Manual page 30

SRX100 Services Gateway Hardware Guide
Table 8: SRX100 Services Gateway Front Panel LEDs (continued)
Number
4
SRX100 Services Gateway Ethernet Port LEDs
On the SRX100 Services Gateway, each Fast Ethernet port has one functional LED
on the left side that indicates Link and Activity. In Figure 5 on page 12, this LED is
marked as 1.
Figure 5: SRX100 Services Gateway Ethernet Port LEDs
The below table applies only to LED marked 1. The states of this LED are as follows:
Table 9: SRX100 Services Gateway Built-In Ethernet Port LEDs
Function
TX/RX/LINK
NOTE: The LED marked as 2 in the graphic is not functional in this release.
12
SRX100 Services Gateway LEDs
Component
Status LED
Color State
Green Blinking
Steady
Unlit Off
Description
The Status LED has the
following indicator colors:
Green and steadily on
indicates that the device
is functioning normally.
Amber and steadily on
indicates that the device
is starting up.
Red and steadily on
indicates that an error is
detected in the device.
Description
Link is active. Data communication is
taking place.
Link is active. No data communication
is taking place.
Link is inactive.
Usage
The Status LED can be used
to determine whether the
device is starting up, is
functioning normally, or has
failed.