Juniper SRX100 Hardware Manual page 100

SRX100 Services Gateway Hardware Guide
Table 29: Component LEDs on the Services Gateway
LED State
Status LED Green
Amber
Red
Alarm LED Red
Amber
Off
Power LED Green
Amber
Off
82
Monitoring the SRX100 Services Gateway Components Using LEDs
Meaning
Indicates that the device is functioning
normally.
Indicates that the device is
starting up.
Indicates that the Reset Config
button is pressed.
Indicates that an error is detected in
the device.
Indicates a major alarm.
Indicates a minor alarm.
Indicates that there are currently no
alarms.
Indicates that the device is functioning
normally.
Indicates that the Power button has
been pressed and quickly released and
the device is gracefully shutting down.
Off indicates that the device is not
receiving power.
Possible Causes and Corrective
Actions
Normal condition. No action is
required.
Normal condition. No action is
required.
Contact JTAC. See "Juniper Networks
Technical Assistance Center" on page
87.
Major alarm indicates a critical
situation on the services gateway
that requires immediate action. See
"Monitoring the SRX100 Services
Gateway Using Chassis Alarm
Conditions" on page 83.
Minor alarm condition requires
monitoring or maintenance. If left
unchecked, it might cause an
interruption in service or degradation
in performance. See "Monitoring the
SRX100 Services Gateway Using
Chassis Alarm Conditions" on page
83
Normal condition. No action is
required.
Normal condition. No action is
required.
Normal condition. No action is
required.
Normal condition if the services
gateway is switched-off. No action is
required.
If you have not powered off the
services gateway, verify that the AC
power cord from the power source
to the device is not damaged, the
socket is in working condition, and
the device has an AC input voltage
between 100 and 240 VAC. See
"Monitoring the SRX100 Services
Gateway Power System" on page 84