Juniper SRX100 Hardware Manual page 62

SRX100 Services Gateway Hardware Guide
4.
5.
6.
7.
Figure 10: Hanging the SRX100 Services Gateway on a Wall
Related Topics
44
Installing the SRX100 Services Gateway on a Wall
If you are using wall anchors to support the chassis, install two pairs of anchors
on the wall, spaced 19 in. (48.3 cm) apart.
Have one person grasp the sides of the device, lift it, and position it on the wall.
Have a second person install two pairs of mounting screws through the bracket
holes on either side of the device to secure it to the wall.
Verify that the mounting screws on one side are aligned with the mounting
screws on the opposite side and that the device is level (see Figure 10 on page
44).
Required Tools and Parts for Installing and Maintaining the SRX100 Services
Gateway on page 29
Preparing the SRX100 Services Gateway for Wall-Mount Installation on page 37
SRX100 Services Gateway Safety Requirements, Warnings, and Guidelines on
page 39
Installing the SRX100 Services Gateway on a Desk on page 42
Installing the SRX100 Services Gateway in a Rack on page 40
Connecting the SRX100 Services Gateway to the Power Supply on page 45