Juniper SRX100 Hardware Manual page 13

About This Guide
Objectives
Audience
Documentation Conventions
This topic includes the following sections:
Objectives on page xiii
Audience on page xiii
Documentation Conventions on page xiii
SRX Series Documentation and Release Notes on page xv
Obtaining Documentation on page xv
Documentation Feedback on page xvi
Requesting Technical Support on page xvi
This guide describes hardware components and installation, basic configuration, and
basic troubleshooting procedures for the Juniper Networks SRX100 Services Gateway.
It explains how to prepare your site for the services gateway installation, unpack and
install the hardware, power on the services gateway, perform initial software
configuration, and perform routine maintenance. After completing the installation
and basic configuration procedures covered in this guide, see the JUNOS Software
configuration guides for information about further JUNOS Software configuration.
This guide is designed for network administrators who are installing and maintaining
a Juniper Networks SRX100 Services Gateway or preparing a site for device
installation. To use this guide, you need a broad understanding of networks in general
and the Internet in particular, networking principles, and network configuration. Any
detailed discussion of these concepts is beyond the scope of this guide.
Table 1 on page xiv defines the notice icons used in this guide.
xiii
Objectives