Configuring Basic Settings For The Srx100 Services Gateway With A Configuration Editor - Juniper SRX100 Hardware Manual

SRX100 Services Gateway Hardware Guide
Table 24: Quick Configuration Set Up Summary (continued)
Field Function
DNS Name Servers Specifies a DNS server that the services
gateway can use to resolve hostnames into
addresses.
Domain Search Adds each domain name that includes the
services gateway to the configuration so that
each domain is included in a DNS search.
Default Gateway Defines a default gateway through which to
direct packets addressed to networks not
explicitly listed in the routing table.
Loopback Address Defines a reserved IP address that is always
available on the services gateway. If no address
is entered, this address is set to
Management Access
Allow Telnet Access Allows remote access to the services gateway
using Telnet.
Allow JUNOScript Allows JUNOScript to access the services
over Clear-Text gateway using a protocol for sending
Access unencrypted text over a TCP connection.
Allow SSH Access Allows remote access to the services gateway
using SSH.
Related Topics

Configuring Basic Settings for the SRX100 Services Gateway with a Configuration Editor

To establish basic connectivity on the services gateway:
1.
2.
3.
In a typical network, the services gateway has the basic settings listed in Table 25
on page 71. Determine the values to set on the services gateway in your network.
70
Configuring Basic Settings for the SRX100 Services Gateway with a Configuration Editor
127.0.0.1/32
SRX100 Services Gateway Basic Connectivity Overview on page 55
Connecting an SRX100 Services Gateway to the J-Web Interface on page 60
Displaying Basic Connectivity Configurations for the SRX100 Services Gateway
on page 73
Configuring Basic Settings for the SRX100 Services Gateway with a Configuration
Editor on page 70
Identify the services gateway.
Connect it to the network.
Specify basic network settings.
Your Action
To add an IP address, type it in the box to the left
of the Add button, then click Add.
To delete an IP address, click on it in the box above
the Add button, then click Delete.
To add a domain name, type it in the box to the left
of the Add button, then click Add.
To delete a domain name, click on it in the box
above the Add button, then click Delete.
Type a 32-bit IP address in dotted decimal notation.
Type a 32-bit IP address and prefix length in dotted
decimal notation.
.
To enable Telnet access, select the box.
To enable JUNOScript access over cleartext, select
the box.
To enable SSH access, select the box.