Power Supply; Main Serial Interface - Datalogic DS2100N Reference Manual

CBX ELECTRICAL CONNECTIONS
To avoid electromagnetic interference when the scanner is connected to a CBX
connection box, verify the jumper positions in the CBX as indicated in its Installation
Manual.
NOTE

4.1 POWER SUPPLY

Power can be supplied to the scanner through the CBX100/500 spring clamp terminal pins
as shown in Figure 20:
The power must be between 10 and 30 Vdc only.
It is recommended to connect the device CHASSIS to earth ground (Earth) by setting the
appropriate jumper in the CBX connection box. See the CBX Installation Manual for details.

4.2 MAIN SERIAL INTERFACE

The signals relative to the following serial interface types are available on the CBX spring
clamp terminal blocks.
If the interface type is not compatible with the current communication handshaking, then the
system forces the handshake to none.
The main interface type and the relative parameters (baud rate, data bits, etc.) can be
set using the Genius™ utility program or the Genius™ based Host Mode Programming
procedure.
Details regarding the connections and use of the interfaces are given in the next paragraphs.
Power Supply
VGND
V+ Earth
in Ground
Figure 20 - Power Supply Connections
4
31