Table of Contents
Advertisement
4.4.4
Power assist (POAS)
If the potentiometer POAS is set to 0°, the door gives no power assist. If the potentiometer is
turned clockwise, the motor will give/increase power assist when the door is opened manually.
The range of the POAS is depending on the spring pre-tension.
4.4.5
Push and go (PAG)
DIP-switch to select Push and Go, ON or OFF. Push and Go is available from any door position.
Push and Go is not active in programme selector setting OFF.
4.4.6
Overhead presence detector (OPD/OPS), frame mounted
When an OPD/OPS sensor is mounted on the frame or operator cover just above the swing side
of the door, it will–when activated–either keep the door open or closed. The sensor input is not
sensitive during opening and closing. Lock-out signal is available as it is required by some
OPD/OPS sensors for proper function.
a closed door will not open, if the OPD/OPS detects activity in the field
an open door will not close, if the OPD/OPS detects activity in the field
during opening, the door will continue to open, even if the OPD/OPS detects activity in the
field
during closing, the door will continue to close, even if the OPD/OPS detects activity in the
field
the OPD/OPS is not active in program mode OFF or manually opened door
during closing, if an activation occur the door will re-open.
4.4.7
Activation delay (AD)
This function requires a constant inner impulse for the specified time before the door will open.
Fixed 2 sec.
During closing the door will reopen immediately if impulsed.
4.4.8
Mat
Mat safety means that:
a closed door will not open, if someone steps on the mat
an open door will not close, if someone steps on the mat
during opening, the door will continue to open, even if someone steps on the mat
during closing, the door will continue to close, even if someone steps on the mat
opening impulses are prevented during closing, if someone steps on the mat
the mat is not active in program mode OFF or manually opened door.
4.5
Functions on the extension unit EXU-SI
Also see page 55 for more information.
4.5.1
KILL function
1007718-US-3.0
In the event that the KILL circuit is activated, all Safety Functions of the
door will be overridden causing the door to close even though an object or
person may be in the door's path of travel, and therefore may be subject to
Issue 2012-06-27
4 How the SW200i works
11
Hide quick links:
Advertisement
Table of Contents
