Signage - Assa Abloy Besam SW200i US Installation And Service Manual

10.2.9 Swinging doors provided with a break away device shall require no more than 50 lbf
(222 N) applied 1 in. from the edge of the locks tile to open. When the door(s) is opened in the
break out mode, powered operating components excluding spring power shall not operate the
doors.
10.2.10 The opening at hinge side of swinging door shall be: a) Less than ¼ in. wide with the
door in any position, or b) At least ¾ in. wide with the door in any position. A door that does
not comply with the above is acceptable if provided with a finger guard.

11. Signage

Consistent with section 2.2.2 of ANSI Z535.4 the "signage and warnings" guidelines of
A156.10 are recognized, industry specific standards that predate the adoption of Z535.4
and are not replaced by the standards set forth therein.
11.1 All Swinging, sliding and folding doors shall be equipped with signage visible from
both sides reading "AUTOMATIC DOOR" with letters ½ in. high minimum. The sign
described in figures B-1, B-3, and B-5 shall be permitted to be used to satisfy this require-
ment.
11.2.1 An arrow sign shall be visible from the approach side of a swinging door mounted on
the door at a height of 58"+ 5 in. from the floor to the center line of the sign. The sign shall be
a minimum of 6 in. in diameter, having a green circle surrounding a black arrow on a white
background.
11.2.2 An International "DO NOT ENTER" sign shall be visible from the side of doors that
swings towards pedestrians attempting to travel in the wrong direction mounted on the door at
a height 58"+ 5 in. from the floor to the center line of the sign. The sign shall be a minimum of
6 in. in diameter, having a red circle with the wording, "DO NOT ENTER", in the red circle.
1007718-US-3.0
AUTOMATIC
DOOR
ILL-02274
DO NOT
ENTER
AUTOMATIC
DOOR
ILL-02273
Issue 2012-06-27
19 ANSI / BHMA A156.10
77